What to do if there is a failure of air pressure in my Mountz HD?
If you are experiencing a failure of air pressure with your Mountz Power Screwdriver, first, turn off the power and check the air inlet outside. If the error persists after pressing the RESET button, check the air lines through the connector, cable, and actuator clutch.
How to prevent overheat of motor in Mountz HD Power Screwdriver?
If your Mountz Power Screwdriver motor overheats, one solution is to use intermittent operation, such as 1 second ON followed by 3 seconds OFF.
What to do if my Mountz HD has communication failure over 1 sec?
If your Mountz Power Screwdriver experiences a communication failure lasting over 1 second, check the cable connection between the driver and the controller.
What to do if there is over current on AMP board circuit in Mountz HD?
If you encounter an over current on the AMP board circuit with your Mountz Power Screwdriver, check for any mechanical load failures and inspect the motor quality.
What to do if my Mountz HD shows a Hall sensor error?
If you are experiencing a Hall sensor error with your Mountz Power Screwdriver, check the cable quality and connectors. Also, inspect the wiring inside the driver.
What to do if I get a driver data error on my Mountz HD?
If you are getting a driver data error with your Mountz Power Screwdriver, ensure that the controller power is off when the driver is connected to the controller.
What to do if my Mountz HD Power Screwdriver has an initial communication failure?
If your Mountz Power Screwdriver experiences an initial communication failure, retry powering on the device after turning it off.
What happens in case of over time of Motor Lock in Mountz HD?
To prevent the motor from overheating, the Mountz Power Screwdriver will stop immediately after 1 second from the motor lock.
General| Type | Pneumatic |
|---|---|
| Air Inlet (NPT) | 1/4" |
| Handle Type | Pistol |
| Start Type | Push-to-Start |
| Power Supply | Pneumatic |
| Chuck Type | 1/4" |
To Next Page
