7. When the speed signal enters the module and appears on the display, it will show the time
set for the Maximum limit count and the Minimum limit count. When the programmed data
starts counting down to zero, the set value will return to the maximum limit, the display will
flash and there will be four short “Bi” “Bi” “Bi” “Bi” sounds for 7 seconds. After 3 seconds, if
there is no signal, the speed will return to zero and stop.
9. If there is no signal or no operation in 4 minutes, the display will turn off automatically. The
programmed data and data for the selected exercises will not be reset. After turning OFF, the
CLOCK and TEMPERATURE will appear.
10. Then press the RESET key for 2 seconds. The system will reset to zero and the clock
adjustment function will enter.
11. In the adjustment function, if a speed signal is input or there is no operation for 15
seconds, the system will automatically exit the adjustment function.
12. The LOAD window will show the LEVEL data according to the VOLTAGE adjustment
button.
8. When the heart rate signal is selected, the display will show the heart rate and the heart
symbol. While showing your heart rate, press the RECALL key and the 60-second
countdown will begin. After zeroing, the display will show GRADE F1 ~ F6. Press the RECALL
key to return to the previous screen. F1 is the best physical condition. F6 is the worst physical
condition.
13. All keys make a sound when pressed.
4. In the USER function, press the MODE key for 2 seconds and the system will zero. The
display will light up and enter the USER adjustment function. In the USER adjustment
function, by pressing the MODE key, the user can adjust P1> SEX> AGE> WEIGHT.
5. In any setting conditions: Press the INCREASE key to adjust / increase the data value
and press the DECREASE key to adjust / decrease values. Pressing the RESET key
erases the programmed value.
6. Press the SCAN key to enter the SCAN function. Every 6 seconds, it will change / show
the next function: SPEED> CALORIES> DISTANCE.
Press the MODE key to exit the SCAN function.
To Next Page
Loading...