10. Place one hand on the tiller, and with the other
hand, release the secure lever of the back handle
(Figure 13, step 1) and bring the handle to an
upright position of 90 degrees (Figure 13, step 2).
For proper operation, do not flip the handle to
180 degrees from a closed position. If you do
and are unable to lift the chair backward, return
the handle to its original position and try again.
Figure 13
Using the handle, pull the back of the chair backward
until it clicks and locks in place (see Figure 14).
Figure 14
11. Continue using the handle to pull up the chair
until it clicks and locks in place (see Figure 15).
Do not sit on the seat before it clicks into place
to prevent it from sliding down again.
Figure 15
12. Open both sides of the handlebar (see Figure
16).
Figure 16
To Next Page
