Moxi SelectAir - Section 11 SelectAir Max; SelectAir Max Pulsate Mode Adjustments; SelectAir Max CPR;Emergency Deflate

40 pages

To Next Page

To Previous Page

2. The Pulsate Mode adjusts as follows:

Low–20% cycle every 15 minutes

Medium–20% cycle every 7 minutes

High–20% cycle every minute.

3. To deactivate the Pulsate Mode, press the Pulsate off button(Fig.23).

Note: You may change the rate of alternating pressure at any time while the Pulsate

Mode is in operation.

Figure 23

Section 11 SelectAir Max

Figure 24

SelectAir,

SelectAir Max,

HybridSelect

Models

Flashing

“Green” Light

(Powerto

ControlUnit)

Note: To assist in deflating the mattress, disconnect the hose at the

mattress or control unit.

CPR/Emergency Deflate

Important: In case of a CPR Emergency, turn power OFF by pressing

the CPR button on the keypad.