QC
PASS
03
· Made of high-strength steel
· High precision pressure sensor for up
to 75 KG
· 16-bit high precision angle sensor
· Braking pressure sensor and angle
sensor fusion algorithm
· Braking spring and damping block
combined
1. Place the pedals on the footrest, use a 2.5mm hexagon wrench to fix the M4*10 screws to
the footrest. It is recommended that all 4 screws of each pedal are tightened to ensure
stability.
2. Connect the wires to the corresponding ports (the connecting wire of the clutch angle
sensor needs to pass through the middle of the brake base, otherwise it may press on the
wire harness after installing the pedal) and use the wire under the pedal base to clamp
the wire harness to prevent the wiring harness is worn or tangled during intense driving.
Product Description
01
Pedal Installment
02
· Adjustable pedal spacing
· Detachable pedal design
· Compatible with floor and professional
cockpit
· Pedal travel software adjustment
brackets
clutch angle sensor port
USB connection port
(connected to the computer)
brake pressure port
brake position sensor port
throttle position sensor port
To Next Page
Loading...
