QC
PASS
03
3. You will see the status of the SRP pedal in the Pit House once the wires are connected
and the USB cable is plugged into the computer. (If it remains gray or does not respond,
please unplug the USB port on the PC, turn off the MOZA Pit House, reconnect the USB
port and turn on the MOZA Pit House)
4. You could check the working status of the pedal, reset the pedal starting point, ending
point, and pedal travel in the MOZA Pit House.
Move left and right to adjust the spacing between the pedals and the base holes, select the
screw hole and then tighten the screw. (The accelerator, brake and clutch are adjusted in
the same way)
How to adjust the pedal spacing
03
To Next Page
Loading...
