EasyManua.ls Logo

MPI UltraScan - Manually Operated;Removable Foot-Drop Section

Default Icon
36 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
UltraScan™ Table
Page 18 of 36 14512-L
DCR-00335
Manually Operated/Removable Foot-Drop Section
The UltraScan™ is provided with a foot drop section that is designed to
comfortably and safely support the patient’s legs at times when the foot stirrups
are not used. The Ultra DBI™ is provided with a retractable Patient Foot Rest to
assist the patient in resting their feet when in the upright, seated position. The
patient’s feet should be placed on the metal strip on the front of the Foot Rest.
WARNING, POTENTIAL FOR INJURY OR DEATH. The foot drop section
is designed to support more weight than a patient’s legs alone, but it is
a collapsible and/or removable section and is not designed to support
full patient body weight. Never allow the patient to apply full body
weight to the extended foot drop section portion of the table while
entering or exiting the table as this may result in instability of the table.
Have the patient enter and exit the table from the side or from the foot
end with the foot section collapsed.
WARNING, POTENTIAL FOR INJURY OR DEATH. Verify both sides of
the foot drop section’s hinges have the pivot locks engaged when
raising the foot section. Failure to have both pivot locks engaged can
result in sudden lowering of the foot drop section.
WARNING, POTENTIAL FOR INJURY. Keep hands clear of the foot
section hinges during operation.
WARNING POTIENTIAL FOR INJURY. Periodically check both sides of
the foot drop section’s hinges to make sure they are between the
receivers mounted on both sides of the table’s frame.
Foot Drop Section Operation
STEP
ACTION
1
To lower the foot drop section, slightly lift the foot end of the foot
drop section and pull back approximately 1 inch. Carefully lower
the foot drop section until it is in a vertical position.
2
To raise the food drop section, grasp the foot drop section near the
bottom and swing it up to ta position slightly above horizontal.
While in this position, push the foot drop section in to engage the
pivot locks.