mPTech HAMMER 5 SMART User Manual

© mPTech 2019. All rights reserved. HAMMER 5 SMART EN
29
In order to be able to use remote factory settings restore via the
portal, you need to have a predefined account in your phone
Creating that account was described in the previous chapter.
Troubleshooting
Message / problem
Possible solution
Insert SIM card
Make sure SIM card has been correctly
installed.
Input PIN
If the SIM card is secured with the PIN code
you have to enter the PIN when turning the
phone on and press <OK>.
Network fail
In areas where signal or reception is weak,
calls may not be possible. Also receiving
calls may not be possible. Move to another
location and try again.
No one can call me
The phone has to be on and within GSM
network reach.
I cannot hear the
caller. / The caller
cannot hear me
The mic. should be close to mouth.
Check if the built-in mic. is not covered.
When a headset is un use, check if it has
been connected correctly.
Check if the built-in speaker isn’t covered.
The connection
cannot be
established
Check if the typed-in phone number is
correct.
Check if the phone number entered to the
[Phonebook] is correct.
Enter the correct phone number if
necessary.
Device maintenance
Follow the instructions below.
 For cleaning use only a dry cloth. Never use any agent with
a high concentration of acids or alkalis.
 Use the original accessories only. Violation of this rule may
result in an invalidation of the warranty.

mPTech HAMMER 5 SMART Specifications

General

Brand	mPTech
Model	HAMMER 5 SMART
Category	Cell Phone
Language	English