To Next Page

To Previous Page

Incompatible memory cards may damage the device and cause the stored data to

be destroyed as well. Incompatibility of memory card can be caused, among others,

by an incorrect file format (required formatting the microSD card) or an unsupported

card capacity - above the value recommended by the manufacturer.

7.3 Charging the battery

Charge the battery before the first use. The battery should be charged by the

attached charger or another charger, intended for this type of equipment. If in

doubt contact the seller or manufacturer service. Use only chargers and wires

recommended by the manufacturer. Using incompatible chargers or cables can

cause explosion of the battery or damage to your device. When the battery is

near a complete discharge, the notification is displayed about a low battery

charge. To continue use of the device charge the battery. If the battery is

completely discharged the device will not switch on, even when the loading

process is ongoing. Before the device can be turned on again, the battery has

to be charged for at least a few minutes. In case of any problems with the

battery or if in need of a replacement, the device should be delivered to the

manufacturer's service center.

To charge the battery one should:

1. Connect micro USB plug to the socket in the device.

Incorrect charger connection (USB cable) can cause damage to the AC

adapter or the device. The damages resulting from improper handling are

not covered by the warranty.

2. Plug the charger into the wall socket. Once you start charging, an icon of

the battery situated in the upper right corner will change to an animated

symbol of lightning. If the device is turned off an animation depicting the

level of battery charge should appear.

The device can heat up during charging. It is a regular occurrence and

should not affect the stability or performance of the device.

3. When the charge reaches 100% it means that the battery is fully charged.

Finish the charging.

4. Disconnect the charger from the wall outlet and the phone, and close the

socket seal securely.

If the phone does not charge properly deliver it (with the charger) to a

service center of the manufacturer.

8. Buttons

• Pressing it will cause the list of open apps to appear, where you can switch

in-between or turn them off.

• Double quick press switches to previously used application.

mPTech Hammer Energy 2 User Manual

Other manuals for mPTech Hammer Energy 2