To Next Page

To Previous Page

7. Before the first start

7.1 Mounting the SIM card.

The device is a cellular phone made in Dual SIM technology (2 SIM cards

handling) allowing the use of two mobile networks simultaneously.

To insert the SIM card(s) correctly, turn off the device, open it with your

fingernail and gently remove the case, take out the battery. Insert the SIM

card(s) into the slot(s) (18) as shown next to the slots. Then carefully insert the

battery pack in such a way that its contacts connect to the connectors in the

smartphone bay and gently replace the cover.

7.2 Installation of the memory card

To insert the memory card correctly, turn off the device, open it with your

fingernail and gently remove the case, take the battery out. Insert the microSD

card into the slot in accordance to the picture (17) placed next to the slot. Then

carefully insert the battery pack in such a way that its contacts connect to the

connectors in the smartphone bay and gently replace the cover.

Use only memory cards recommended by the manufacturer. Pay attention to

the selection of the proper format-the microSD card, capacity and type/class.

Incompatible memory cards may damage the device and cause the stored data to

be destroyed as well. Incompatibility of memory card can be caused, among others,

by an incorrect card format (required format microSD) or an unsupported card

capacity - above the value recommended by the manufacturer.

7.3 Inserting, removing and recharging the battery

Use only chargers and wires recommended by the manufacturer. Using

incompatible chargers or cables can cause explosion of the battery or damage

to your device.

Incorrect charger connection (USB cable) can cause damage to the AC adapter

or the device. The damages resulting from improper handling

are not covered by the warranty.

The device can heat up during charging. It is a regular occurrence and should

not affect the stability or performance of the device.

If the phone does not charge properly deliver it (with the charger) to a service

center of the manufacturer.

Before the first use insert the battery correctly, use your fingernail to open and

gently remove the back housing, carefully insert the battery so that its contacts

are connected to the connectors in the smartphone bay and gently replace the

housing.

Once completed charge the battery. The battery should be charged by the

attached charger or another charger, intended for this type of equipment.

If in doubt contact the seller or manufacturer service.

mPTech myPhone FUN 7 LTE User Manual

Questions and Answers: