EasyManua.ls Logo

mPTech myPhone Halo C - Button 15: Phone Keypad; Button 16: LED; Button 17: Contacts; Port 18: MicroUSB

mPTech myPhone Halo C
46 pages
Go to English
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN © mPTech 2020. All rights reserved. Halo C
16
15
Phone
keypad
Buttons for dialing a phone number
on the main screen and entering
letters or numbers in the SMS
writing mode.
16
LED
Diode is used as a torch.
17
Contacts
Allow you to connect your phone to
the charging base.
18
MicroUSB
port
When connected enables recharging
the battery. You can transfer data
(photos, videos, music) when you
connect it to your computer.
19
Gap
Allows to take off a cover of the
phone.
Turning the phone on/off
To turn the phone on/off press and hold Red handset until the
phone switches on. If directly after turning the phone on you will
see the PIN code request, (in form of “****”) type the code and
press button Menu.
Inserting SIM card(s), memory card and battery
If the phone is switched on - switch it off. Remove the back cover
of the phone - use your fingernail to raise it using the gap in the
case. Insert the SIM card(s) - place the SIM card(s) with its (their)
golden contacts facing down as the recess is embossed.
Insert the memory card - to open the cover of the card reader
slide it gently up. Insert the microSD memory card with its gold
contacts facing down, the way in which the slot is made. Close the
flip by sliding it delicately downwards. Insert the battery so that
its gold contacts touch the tripple connector in the phone bay. Put
on and gently press down the cover until you hear the click of the
latches. Make sure the cover is well attached.

Table of Contents

Related product manuals