WARNING SYMBOLS AND DEFINTIONS
This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety
messages that follow this symbol to avoid possible injury or death.
Indicates a hazardous situation which, if not avoided, could result in death or serious injury.
Indicates a hazardous situation which, if not avoided, could result in minor or moderate injury.
Indicates a hazardous situation which, if not avoided, could result in minor or moderate injury.
IMPORTANT SAFETY INFORMATION
AWARNING
Read all safety warnings and instructions. Failure to heed these markings may result in personal injury and/or property
damage.
Save all warnings and instructions for future reference.
The warnings, precautions, and instructions discussed in this manual cannot cover all possible conditions and situations that may occur.
It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be
supplied by the operator
Work area
1. Keep the work area clean and well lighted. Cluttered benches and dark areas increase the risk of injury to persons.
2. Keep bystanders and children away while operating the tool. Distractions can result in loss of control of the tool.
Personal safety
1. Stay alert. Watch what you are doing and use common sense when operating the tool. Do not use the tool while tired or
under the influence of drugs, alcohol, or medication. A moment of inattention while operating the tool increases the risk of
injury to persons.
2. Dress properly. Do not wear loose clothing or jewelry. Contain long hair. Keep hair, clothing, and gloves away from
moving parts. Loose clothes, jewelry, or long hair increases the risk of injury to persons as a result of being caught in moving
parts.
3. Do not overreach. Keep proper footing and balance at all times. Proper footing and balance enables better control of the tool in
unexpected situations.
4. Use safety equipment. Wear safety goggles and heavy-duty work gloves during use
Tool use and care
1. Do not force the tool. Use the correct tool for the application. The correct tool will do the job better and safer at the rate for which
the tool is designed.
2. Store the tool when it is idle out of reach of children and other untrained persons. A tool is dangerous in the hands of untrained
users.
3 Check for misalignment or binding of moving parts, breakage of parts, and any other condition that affects the tool's
operation. If damaged, have the tool serviced before using. Many accidents are caused by poorly maintained tools.
4 Use only accessories that are identified by the manufacturer for the specific tool model. Use of an accessory not intended for
use with the specific tool model, increases the risk of injury to persons
5 Avoid off-center loads. If the Pump seems unusually hard to operate, immediately stop. Adjust the Ram to eliminate or diminish an
off-center load.
Addresses practices not related to personal injury.
WARNING SYMBOLS AND DEFINTIONS
To Next Page
Loading...