Mr. Coffee BVMC-SC500 SERIES - Brewer Overview and Setup; Parts Identification; K-Cup Brewing Procedure; K-Cup Assembly Hazards

6 7
1. BREW / OFF
2. SERVING SIZE
BUTTON
3. STRONG BREW
4. DRIP TRAY PLATE
PARTS DIAGRAM
1. Place Brewer upright
on a flat surface,
remove protective
sheet and plug into
outlet.
2. DO NOT remove or
puncture the foil lid of
the K-Cup
®
Pack.
Ensure you are using
the K-Cup
®
Pack
Holder.
3. Press lock tab and pull
K-Cup
®
Holder forward.
SET-UP & HOW TO BREW WITH K-CUP
®
PACKS
10
7
1
2
3
6
8
9
4
CAUTION:
• There are two sharp
needles that puncture
the K-Cup
®
Pack, one
above the K-Cup
®
Pack
Holder and the other
at the bottom of the
K-Cup
®
Pack Holder.
To avoid risk of injury,
do not put your fingers
in the K-Cup
®
Pack
Housing Assembly.
• Do not remove K-Cup
®
Holder during the
brew cycle.
• Do not open the lid
or remove the water
reservoir during the
brew cycle.
5
5. DRIP TRAY
6. PULL HANDLE & INSERT
K-CUP
®
PACK
7. K-CUP
®
HOLDER
8. K-CUP
®
HOLDER LID
9. PRESS LOCK TAB
10. REMOVABLE WATER
RESERVOIR
11. MY GROUNDS
TM
REUSABLE
FILTER
4. Lift and open the top
of the K-Cup
®
Holder.
5. Place K-Cup
®
Pack
inside of K-Cup
®
Pack
Holder and close
K-Cup
®
Holder Lid.
6. Push K-Cup
®
Holder
back into place. The
locking tab will snap to
lock it in place.
11
BVMC-SC500 Series_16ESM1.indd 6-7 5/5/16 10:44