Page 11 mrcool.com
Installation Summary - Indoor Unit
Installation Instructions
– Indoor Unit
PRIOR TO INSTALLATION:
Before installing the indoor unit, refer to the
label on the product box to make sure that
the model numbers of the indoor units match
the model number of the outdoor unit.
Step 1: Select installation location
Before installing the indoor unit, you must choose
an appropriate location. The following standards
will help you choose an appropriate location.
Proper installation locations meet the
following standards:
Good air circulation
Convenient drainage
Noise from the unit will not disturb
other people
Firm and solid—the location will not vibrate
Strong enough to support the weight of
the unit
A location at least one meter from all other
electrical devices (e.g., TV, radio, computer)
DO NOT install unit in the following locations:
NOTE ABOUT WALL HOLE:
Near any source of heat, steam, or
combustible gas
or clothing
Near any obstacle that might block air
circulation
Near a doorway
In a location subject to direct sunlight
If the
While choosing a location, be aware that you
should leave ample room for a wall hole
(see Drill wall hole for connective piping
step)
for the signal cable and refrigerant
piping that connect the indoor and outdoor
units to pass through. The default position
for all piping is the right side of the indoor
unit (while facing the unit). However, the unit
can accommodate piping to the left or right.
3
Indoor Unit Installation
To Next Page
Loading...
Need help?
General
