Operation Of Buttons
Page 4mrcool.com
MODE
FA N
TE MP
S LE E P
ON/OF F
S ILE NC E
F P
TIME R
ON
TIME R
OFF
1
2
4
3
5
6
S WING DIR E C T
LE D F OLLOW
ME
TUR BO S E LF
C LE AN
8
9
7
10
12
11
13
14
UP Button
Push this button to increase the indoor temperature
setting in 1° increments (°F or °C depending on mode)
up to 86°F (30°C).
DOWN Button
Push this button to decrease the indoor temperature
setting in 1° increments (°F or °C depending on mode)
down to 62°F (16°C).
SILENCE/FP Button
• Activates or disables the SILENCE function. If pushed for
more than 2 seconds, the 'FP' function will be activated;
pushing more than 2 seconds again disables this function.
• When the SILENCE function is activated, the compressor
will operate at a low frequency and the indoor unit will
create a faint breeze that will reduce the noise to the
lowest level and create a quiet and comfortable
environment. Due to low frequency operation of the
compressor, insufficient cooling and heating capacity may
occur.
• The 'FP' function can only be activated during the heating
operation (only when the setting mode is HEAT). The unit
will operate at a set temperature of 46°F (7.8°C).The
display window of the indoor unit will display 'FP'. Pressing
ON/OFF, SLEEP, FP, MODE, FAN SPEED UP or DOWN
during operation will cancel the 'FP' function.
TIMER ON Button
Press this button to initiate the auto-on time sequence.
Each press will increase the auto-timed setting in 30
minute increments. When the time setting displays
10.0, each press will increase the auto-timed setting by
60 minute increments.
To cancel the auto-timed program, simply adjust the
auto-on time to 0.0.
7
8
9
NOTE
Temperature control is not available in FAN mode.
Press and hold UP and DOWN buttons together for
3 seconds to alternate the temperature display
between the °F & °C scale.
To Next Page
Loading...
