MicroTrap™ Operations Manual - Edition 4.4
2
Photographs of these hardware components are contained in Section 3.1.
1. MicroTrap™ VOD/Data Recorder.
2. MicroTrap™ Battery Charger that is labeled 120 VAC or 220 VAC depending on your country’s mains power.
3. Communications Cable - USB cable.
4. BNC Adapters x2.
5. Carrying Case.
6. DAS™ Data Acquisition Suite Operations Software on USB.
7. MicroTrap™ Operations Manual.
8. DAS™ Data Acquisition Suite Manual.
9. If Optional Scope Upgrade has been purchased, an additional 4x BNC Adapters will be included.
10. VOD resistance probes: VOD PROBERODs and/or VOD PROBECABLE and/or VOD PROBECABLE-LR. (Optional)
1.1 MicroTrap™ Hardware Included
All of the steps detailed in this Chapter should be completed before the Operator goes into
the field to conduct a VOD test:
1. Ensure that all MicroTrap™ components have been received and are available.
2. Ensure that the DAS™ Data Acquisition Suite is installed and operational according to the
DAS™ Data Acquisition Suite Software manual.
3. Ensure that the Operator’s computer and MicroTrap™ are able to communicate with
each other.
4. Program the MicroTrap’s internal recording parameters using the MicroTrap™ Software.
Refer to the DAS™ Data Acquisition Suite Manual for installation procedure.
Overview
1.2 Installing The DAS™ Data Acquisition Suite Software
To Next Page
Loading...