MRP ribbon User Manual

MAINTENANCE DESCRIPTION
FREQUENCY
(in hours)
REPLACE BATH OIL
NORMAL CONDITIONS:
50
MUDDY CONDITIONS:
30
REPLACE WIPER SEALS
NORMAL CONDITIONS:
100
MUDDY CONDITIONS:
75
CHECK AIR SPRING AND RELUBE IF NEEDED 50
CHANGE DAMPER OIL 200
CHECK FASTENERS 30
CHECK AIR PRESSURE 30
INSPECT STANCHIONS EVERY RIDE
CLEAN DIRT AND MUD FROM STANCHIONS EVERY RIDE
SUGGESTED MAINTENANCE INTERVALS
TORQUE VALUES
FASTENER TORQUE
COMPRESSION BOLT (DAMPER SIDE) 70-75 LB-IN, 8 Nm
COMPRESSION BOLT (AIR SPRING SIDE) 70-75 LB-IN, 8 Nm
BOLT-ON AXLE (OPTIONAL) 105 - 130 LB-IN, 12-15 Nm
TOP CAPS 110 LB-IN, 12.4 Nm
REGISTER YOUR RIBBON ONLINE AT MRPBIKE.COM
A link to registration can be found under the “SUPPORT” heading.
While there check out our “TECH RESOURCES” section for more
information on the tuning, maintenance, and the technology found in
your MRP fork.
MRP IS A DIVISION OF:
MOUNTAIN RACING PRODUCTS
580 N WESTGATE DR
GRAND JUNCTION, CO 81505
970.241.3518
GET THE LATEST INFO ON MRP PRODUCTS
Follow us on:
Facebook.com/MRPbike
Instagram.com/MRPbike
OWNER’S
MANUAL

MRP ribbon Specifications

General

Brand	MRP
Model	ribbon
Category	Bicycle Accessories
Language	English

Summary

Torque Values

Compression Bolt (Damper Side) Torque

Specified torque value for the compression bolt on the damper side of the fork.

Compression Bolt (Air Spring Side) Torque

Specified torque value for the compression bolt on the air spring side of the fork.

Bolt-On Axle Torque

Top Caps Torque

Important Consumer Safety Information

General Safety Warning

Critical warnings about the dangers of riding and improper maintenance of bicycles and components.

Fork Installation

Steerer Tube Measurement and Cutting

Instructions for measuring and cutting the steerer tube to ensure proper stem installation.

Crown Race Installation

Procedure for pressing the crown race onto the new fork's steerer tube.

Headset Assembly and Adjustment

Brake and Wheel Installation

Warranty

Warranty Inspection and Service Process

Procedure for seeking warranty inspection or service, including contact and shipping instructions.

Fulfil Air Spring Fill Procedure

Air Spring Filling Process

Procedure for filling the positive and negative air chambers of the suspension fork.

Air Pressure Chart

Chart providing recommended positive and negative air pressure settings based on rider weight.