MRP hazzard User Manual

MAINTENANCE SCHEDULE
Maintenance frequency may vary depending on the number of hours
the shock is ridden and the condition under which it is ridden. Heat,
frame design, dust, mud, and adjustment settings are all factors that
need to be taken into consideration in determining the frequency of
basic maintenance and oil changes.
AFTER EACH
USE
END OF EACH
SEASON
ANNUALLY
Clean under
the bottom-out
bumper
Ye s Ye s Ye s
Clean shock
exterior
Ye s Ye s Ye s
Check shaft
for damage or
rust
Inspect Inspect Inspect
Check seal
head for leaks
or loosening
Inspect Inspect/Replace Replace
Check nuts for
loosening
Inspect Inspect Inspect
Check DU
bushings
Inspect Inspect Inspect
Check spring Inspect Inspect Inspect
Change oil,
piston and
wearband,
clean interior
parts, check
nitrogen
Recommended
IMPORTANT NOTE:
NOTE: MRP RECOMMENDS SENDING YOUR SHOCK EXCLUSIVELY TO MRP OR
A RECOMMENDED SERVICE CENTER FOR ALL YOUR OIL CHANGE AND SEAL
REPLACEMENT MAINTENANCE.
MORE TUNING INFORMATION AT
OWNER’S
MANUAL

MRP hazzard Specifications

General

Brand	MRP
Model	hazzard
Category	Bicycle Accessories
Language	English

Summary

MAINTENANCE SCHEDULE

Clean under the bottom-out bumper

Regularly clean under the bottom-out bumper after each use, at season end, and annually.

Clean shock exterior

Clean the shock exterior after each use, at season end, and annually.

Check shaft for damage or rust

Inspect the shock shaft for any signs of damage or rust after each use and at season end.

Check seal head for leaks or loosening

Inspect the seal head for leaks or loosening after each use, and replace if necessary at season end.

Check nuts for loosening

Inspect shock nuts for loosening after each use and at season end.

Check DU bushings

Inspect DU bushings for wear or damage after each use and at season end.

Check spring

Inspect the spring for proper condition after each use and at season end.

Change oil, piston and wearband, clean interior parts, check nitrogen

Recommended service including oil change, piston, wearband, and nitrogen check.

IMPORTANT CONSUMER SAFETY INFORMATION

WARRANTY

SHRED LEVER ADJUSTMENT

HIGH-SPEED COMPRESSION

What to do if you need warranty inspection or service

DISCLAIMER

MOUNTING HARDWARE

SPRING REMOVAL & INSTALLATION

PRELOAD

REBOUND

LOW-SPEED COMPRESSION