MSA EVOLUTION 6000 Series - Truck Mounted Charger System Installation; Installation Kit Components; Required Tools and Materials

EVOLUTION 6000 series Truck Mounted Charger
6
Fitting the Truck Mounted Charger System
MSA
US
2 Fitting the Truck Mounted Charger System
The truck mounted charger system is mounted in the vehicle using the vehicle installation kit.
For installation, a sufficiently large flat surface is required which:
- guarantees comfortable access to the camera
- does not require a cable longer than 10 feet (3 meters) to the power source and
- protects the charging system from water spray and extreme temperatures.
Installation Kit
Fig. 1 Installation kit
Necessary Tools and Material
- Installation kit for truck charger system
- Power drill and metal drill bits [#7 (0.201) or 5 mm and 9/32 (0.281) or 7 mm]
- Thread tap 1/4-20 or M6
- Phillips screwdriver with long shank
- 4 stainless steel 3/4-20 bolts or M 6 x 25 bolts
- 5 Amp fuse
- ON / OFF circuit breaker
- Strain relief bushing for power supply cable
1 Suspension rails 3 Screws
2 Anti-vibration mounting washers 4 Spring nuts
2
1
3
4