Luminator Cap Lamp
13
Maintenance
GB
6 Maintenance
6.1 Maintenance Intervals
6.2 Visual Test and Function Test
Visual Test
(1) Inspect the device for possible damages like for example dirt, deforma-
tions, cracks or loosen parts.
(2) Defective or damaged parts have to be replaced immediately.
Functional Test
The device has to be tested for unrestricted mobility.
(1) Turn ON/OFF, to check the lamp.
(2) Gently press the ON/OFF button, to check the operation mode.
6.3 Cleaning
Do not use solvents to clean the device.
(1) Clean the device with a clean soft cloth.
(2) Avoid any cleaning method that may lead to scratching of the lens or re-
flectors.
Attention!
To maintain the intrinsic safety certification of the device all per-
sonnel performing any service or repair have to be trained and cer-
tified in maintaining intrinsically safe equipment.
Work to be carried out
Maximum Intervals
Before Use After Use
Cleaning X
Visual and Functional Check X X
To Next Page
Loading...