MSI 760GM - Page 49

3-10
BIOS Setup ▍
MS-7596
BIOS Setup ▍
MS-7596
IOAPIC Functon
Ths 󰘰eld s used to enable or dsable the APIC (Advanced Programmable Interrupt
Controller). Due to complance wth PC2001 desgn gude, the system s able to run n
APIC mode. Enablng APIC mode wll expand avalable IRQ resources for the system.
MPS Table Verson
Ths 󰘰eld allows you to select whch MPS (Mult-Processor Spec󰘰caton) verson to be
used for the operatng system. You need to select the MPS verson supported by your
operatng system. To 󰘰nd out whch verson to use, consult the vendor of your operatng
system.
Prmary Graphc’s Adapter
Ths settng spec󰘰es whch graphc card s your prmary graphcs adapter.
PCI Latency Tmer
Ths tem controls how long each PCI devce can hold the bus before another takes
over. When set to hgher values, every PCI devce can conduct transactons for a longer
tme and thus mprove the e󰘯ectve PCI bandwdth. For better PCI performance, you
should set the tem to hgher values.
CPU Feature
Press <Enter> to enter the sub-menu and the followng screen appears:
C1E Support
To enable ths tem to read the CPU power consumpton whle dle. Not all proces
-
sors support Enhanced Halt state (C1E).
SVM Support
Ths tem s used to enable/ dsable SVM.
Chpset Feature
Press <Enter> to enter the sub-menu and the followng screen appears:
HPET
The HPET (Hgh Precson Event Tmers) s a component that s part of the chpset.
You can to enable t, and wll provde you wth the means to get to t va the varous
ACPI methods.
▶
▶
▶
▶
▶
▶
▶
▶
▶