The message will show up on the bottom, press any key to use maximum capacity
or press [Ctrl-Y] to modify array capacity manually.
6.
The LD creation is done, the screen shows the LD information as below.Press ESC
key to the main screen.
7.
Important
The default capacity is the full capacity of the selected hard drives.
If you allocate the rst LD capacity manually, you can create second LD with remain-
ing capacity of the selected hard drives.
•
•
Press ESC key to exit the utility, a message “System is going to REBOOT! Are You
Sure?” will display, answer “Y” to exit it and the system will reboot.
8.
To Next Page
Loading...
