6
ATX 24-Pin Power Connector: ATX1
This connector allows you to connect an ATX 24-pin power
supply. To connect the ATX 24-pin power supply, make sure the
plug of the power supply is inserted in the proper orientation
and the pins are aligned. Then push down the power supply
firmly into the connector. You may use the 20-pin ATX power
supply as you like. If you like to use the 20-pin ATX power
supply, please plug your power supply along with pin 1 & pin 13
(refer to the image at the right hand).
GND
+3.3V
-12V
+3.3V
+3.3V
+3.3V
+5V
+5V
+5V
+5V
+5V
Res
GND
GND
GND
GND
5VSB
+12V
+12V
ATX 12V Power Connector: PWR1
This 12V power connector is used to provide power to the CPU.
+12V
+12V
Important:
Make sure that all the connectors are connected to proper ATX power supplies to ensure
stable operation of the mainboard.
Power supply of 350 watts (and above) is highly recommended for system stability.
ATX 12V power connection should be greater than 18A.
Floppy Disk Drive Connector: FDD1
This connector supports 360KB, 720KB, 1.2MB, 1.44MB or
2.88MB floppy disk drive.
IDE Connector: IDE1
This connector supports IDE hard disk drives, optical disk
drives and other IDE devices.
Important:
If you install two IDE devices on the same cable, you must configure the drives
separately to master/ slave mode by setting jumpers. Refer to IDE device’s
documentation supplied by the vendors for jumper setting instructions.
Serial ATA Connector: SATA1~4
This connector is a high-speed Serial ATA interface port. Each
connector can connect to one Serial ATA device.
Important:
Please do not fold the Serial ATA cable into 90-degree angle. Otherwise, data loss may
occur during transmission.
Fan Power Connectors: FAN_CPU1,
FAN _SYS1, FAN_SYS2
PDF created with pdfFactory Pro trial version www.pdffactory.com
To Next Page
Loading...
