3-17
BIOS Setup
Re-Call VGA BIOS from S3
When ACPI Standby State is set to [S3/STR], users can select the options in this
field. Selecting [Enabled] allows BIOS to call VGABIOS to initialize the VGA card
when system wakes up (resumes) from S3 sleep state. The system resume time is
shortened when you disable the function, but system will need an AGP driver to
initialize the VGA card. Therefore, if the AGP driver of the card does not support the
initialization feature, the display may work abnormally or not function after resuming
from S3. Setting options: [Enabled], [Disabled].
Suspend Time Out (Minute)
If system activity is not detected for the length of time specified in this field, all
devices except CPU will be shut off. Settings: [Disabled], [1], [2], [4], [8], [10], [20],
[30], [40], [50], [60].
Power Button Function
This feature allows users to configure the Power Button function. Settings are:
[On/ Off] The power button functions as a normal power-on/-off
button.
[Suspend] When you press the power button, the computer enters
the suspend/sleep mode, but if the button is pressed for
more than four seconds, the computer is turned off.
Restore on AC Power Loss
This setting specifies whether your system will reboot after a power failure or
interrupt occurs. Available settings are:
[Power Off] Leaves the computer in the power off state.
[Power On] Leaves the computer in the power on state.
[Last State] Restores the system to the previous status before power
failure or interrupt occurred.
Wakeup Event Setup
Press <Enter> to enter sub-menu and the following screen appears.
Resume By PS/2 Keyboard
The item specifies how the system will be awakened from power saving mode
when input signal of the PS2 keyboard is detected. Use the <PageUp> &
<PageDown> keys to select the options. When selecting [Password], enter the
desired password. Setting options: [Disabled], [Password], [Hot Key].
To Next Page
Loading...
