9
Mining System Installation Guide
Resetting BIOS by Clear CMOS Button
Power off your computer. Press and hold the Clear CMOS button for about 5-10
seconds to reset BIOS to default values.
Power button
Clear CMOS button
Reset button
Resetting BIOS
This section will describe how to clear CMOS with jumper or button.
Resetting BIOS by JBAT1 Jumper
There is CMOS memory onboard that is external powered from a battery located on
the motherboard to save system configuration data. If you want to clear the system
configuration, set the jumpers to clear the CMOS memory.
Keep Data
(default)
Clear CMOS/
Reset BIOS
Resetting BIOS to default values
1. Power off the computer and unplug the power cord
2. Use a jumper cap to short JBAT1 for about 5-10 seconds.
3. Remove the jumper cap from JBAT1.
4. Plug the power cord and power on the computer.
To Next Page
Loading...
Need help?
General
