Chapter 1
1-21 Getting Started
Boot up the computer and install the drivers and software included in your video
card package. For more information, please refer to the manual that came with
your video card.
After all of the hardware and software has been properly installed, reboot the
system. After entering the operating system (OS), right click on the desktop and
choose the “Catalyst Control Center”.
3.
4.
The CrossFire™ setting must be enabled to allow CrossFire™ mode to operate.
The follow screen appears in the Catalyst Control Center. Depending on your
operating system, the screen may look dierent.
5.
Important
A CrossFire
TM
system has four possible display modes:
SuperTiling
Scissor Mode
Alternate Frame Rendering
Super Anti-aliasing.
For more details, please consult the graphics card manual.
•
•
•
•
To Next Page
Loading...
