3-17 BIOS Setup
To clear a set password, press <Enter> when you are prompted to enter a new
Trusted Computing
Sets TPM (Trusted Platform Module) function.
TPM SUPPORT [Disabled]
Enables or disables the TPM function to build the endorsement key for accessing
the system.
Press <Enter> to enter the sub-menu.
Chassis Intrusion [Disabled]
This function will be available if the chassis equips a chassis intrusion switch.
Once the chassis is opened, the system will record and issue a warning message.
To clear the warning message, set the item to [Reset], then it will return to [Enabled]
later. [Options: Disabled, Enabled, Reset]
Discard Changes and Exit
Exit BIOS setup without saving any change. This it is used to abandon all changes and
exit BIOS setup.
Save Changes and Reboot
This item is used to save all changes and reboot the system.
Save Changes
This item is used to save current changes.
Discard Changes
This item is used to discard current all changes and restore to the previous values.
Restore Defaults
This item is used to restore/ load all default values by the BIOS vendor.
Boot Override
The installed boot-able devices will appear on this menu, you can select one of them be
a boot device to start booting.
To Next Page
Loading...
