3-9
BIOS Setup
USB-FDD The system will boot from USB-interfaced floppy drive.
USB-ZIP The system will boot from any USB-interfaced ATAPI
ZIP drive
USB-CDROM The system will boot from the USB-interfaced CD-ROM.
USB-HDD The system will boot from the USB-interfaced HDD.
LAN The system will boot from the Network drive.
Disabled Disable this sequence.
Boot Other Device
Setting the option to Enabled allows the system to try to boot from other
devices if the system fails to boot from the 1st/2nd/3rd boot device.
Settings: Enabled, Disabled.
CPU Internal Cache & External Cache
The item allows you to turn on or off CPU’s internal (L1) and external (L2)
cache. Settings: Enabled and Disabled.
CPU L2 Cache ECC Checking
This setting allows you to enable or disable the ECC (Error-Correcting Code)
feature for error detection and correction when data passes through L2 cache
memory. Setting options: Enabled, Disabled.
Swap Floppy
Setting to Enabled will swap floppy drives A: and B:.
Seek Floppy
Setting to Enabled will make BIOS seek floppy drive A: before booting the
system. Settings: Disabled, Enabled.
Boot Up NumLock Status
This setting is to set the Num Lock status when the system is powered on.
Setting to On will turn on the Num Lock key when the system is powered on.
Setting to Off will allow users to use the arrow keys on the numeric keypad.
MSI Reminds You...
Available settings for “1st/2nd/3rd Boot Device” vary depend-
ing on the bootable devices you have installed. For example, if
you did not install a floppy drive, the setting “Floppy” does not
show up.
To Next Page
Loading...
