59
JDASH1 : Tuning Controller connector
This connector is used to connect an optional Tuning Controller module.
Pin Signal Name Pin Signal Name
1 No Pin 2 NC
3 MCU_SMB_SCL_M 4 MCU_SMB_SDA_M
5 VCC5 6 Ground
7 PSIN#_R 8 FP_RST#_R
9 NC 10 OC_FS
11 BLK+ 12 BLK-
13 CLRCMOS_EN 14 NC
1
2 14
13
V-Check Points Lite
These voltage checkpoints are used to measure the current system voltages. A
multimeter (not included) will be required to check voltages. To measure voltage,
place test leads on the Ground (or screw mounting hole) and a specific V-Check Point.
Please refer to the manual of your multimeter for more information.
DDR1: CPU VDDIO voltage
SOC1: SOC voltage
CORE1: Core voltage
GND1: Ground
To Next Page
Loading...
