51
Onboard LEDs
EZ Debug LED
These LEDs indicate the debug status of the motherboard.
Onboard LEDs
BOOT - indicates the booting device is not
detected or fail.
DDR - indicates DRAM is not detected or fail.
CPU
VGA - indicates GPU is not detected or fail.
JPWRLED1: LED power input
This connector is used by retailers to demonstrate onboard LED lights.
JPWRLED1 - LED power input
LED_SW1: EZ LED Control
This switch is used to switch on/ off all the LEDs of motherboard.
LED_SW1
LED_OFF
LED_ON
To Next Page
Loading...
