12
“Set Local Device Only” button
The “Set Local Device Only” button is used to change the network name of the local
device only. After changing the network name to a new one, all the devices existing in the
same network before will no longer be able to communicate or respond to you, because
they will not have the same network name with the local device.
“Set All Devices” button
The “Set All Devices” button is used to change the whole logical network’s devices, both
local and remote, that showed in the Main frame. Please fill in each remote device’s
password in advance following the instructions in Sec 3.1(“Enter Password” button) so
that this function can proceed normally.
To Next Page
Loading...
