This product is intended for installation only by expert users. Please consult
with a qualified technician for installation. Improper installation may result in
damage to your equipment. EK Water Blocks assumes no liability whatsoever,
expressed or implied, for the use of these products, nor their installation. The
following instructions are subject to change without notice. Please visit our
web site at www. ekwb.com for updates. Before installation of this product
please read important notice, disclosure and warranty conditions printed on
the back of the box.
Before you start using this product please follow these basic guidelines:
Please carefully read the manual thoroughly before beginning with the
installation process!
Please remove your motherboard from the computer to assure safest
mounting process in order to prevent any possible damages to your CPU
and/or motherboard’s circuit board (PCB).
The EK- Fittings require only a small amount of force to screw them firmly in
place since the liquid seal is ensured by the rubber o-ring gaskets.
The use of quality, market proved corrosion inhibiting coolants is always
strongly recommended for any liquid cooling system.
To Next Page
Loading...
Need help?
General
