MS-4413
Accelerated Graphic Port
1.4 Install Enhance Drivers For IBM
®
OS/2
Follow the procedure listed below to install the OS/2 display driver.
If you are installing OS/2 for the first time, install the OS/2 for VGA
first and reconfigure the driver later.
To install MS-4415 Enhance Drivers, follow the steps below:
Step 1: Open an OS/2 Window.
Step 2: Insert the CLAGP_DRV CD into CD-ROM drive: and click
OK.
Step 3: Change to the CD-ROM drive.
Step 4: At the CD-ROM prompt type
OS/2\SETUP C
where ‘C’ signifies your boot drive, then press[Enter].
Step 5: From the Display Driver Install dialogue box, check Primary
Display and click OK.
Step 6: Next, verify the correct Source Directory and click Install to
begin the installation process.
Step 7: From the Display Driver Install information box, click OK to
proceed.
Step 8: The Setup Program will take you back to the OS/2 Window
once the driver has been copied to your bootable drive.
Type
EXIT
at the prompt and click OK.
Step 9: Remove the driver form the CD-ROM drive:
Step 10: Shutdown to restart OS/2 with your newly installed OS/2
driver.
2-21
To Next Page
Loading...
