BIOS Setup
3-19
IDE HDD Block Mode
Block mode is also called block transfer, multiple commands, or multiple sector
read/write. If your IDE hard drive supports block mode (most new drives do),
select Enabled for automatic detection of the optimal number of block read/
writes per sector the drive can support. The settings are: Enabled, Disabled.
Init Display First
This item specifies which VGA card is your primary graphics adapter. Settings:
PCI Slot and AGP.
AGP Auto Calibration
This setting disables/enables the AGP auto calibration. Setting options:
Disabled, Enabled.
To Next Page
Loading...
