BIOS Setup Industrial Computer Board
3-7
BIOS Setup Industrial Computer Board
Super IO Configuration
Serial Port 1/ 2/ 3/ 4/ 5/ 6
This setting enables/disables the specified serial port.
Change Settings
This setting is used to change the address & IRQ settings of the specified
serial port.
Parallel Port
This setting enables/disables the parallel port.
Change Settings
This setting is used to change the address & IRQ settings of the parallel
port.
Device Mode
Select an operation mode for the parallel port.
Watch Dog Timer
You can enable the system watch-dog timer, a hardware timer that generates
a reset when the software that it monitors does not respond as expected each
time the watch dog polls it.
FIFO Mode
This setting controls the FIFO data transfer mode.
▶
▶
▶
▶
▶
▶
▶
▶
To Next Page
Loading...
Need help?
General
