2-7
OSD Setup
2-6
1st Level Menu 2nd/3rd Level Menu Description
Anti Motion Blur
(OFF)
■ For PAG272QR, PAG272QR2, and
PAG272R�
■ Brightness cannot be adjusted when Anti
Motion Blur is set to ON�
■ When Response Time is set to Fastest with
at least 75Hz Screen Refresh Rate, Anti
Motion Blur will be automatically enabled�
■ When Screen Refresh Rate is lower than
75HZ, Anti Motion Blur cannot be enabled
and Response Time cannot be set to
Fastest�
■ When Anti Motion Blur is enabled, HDCR
cannot be enabled and will be grayed out�
■ This function is recommended for cinema,
FPS and Racing games�
■ When FreeSync is enabled, Anti Motion Blur
will be grayed out�
(ON)
Zero Latency
(OFF)
■ Users can adjust this item in any mode , any
input source , any resolution and any screen
refresh rate�
■ While FreeSync is enabled, Zero Latency
have to set to ON�
(ON)
Refresh Rate Location Left Top ■ Users can adjust Refresh Rate in any Mode�
■ Default Refresh Rate Location is Left Top�
Location is adjustable in OSD Menu� Press
the Middle Button to conrm and apply your
Refresh Rate Location�
■ This monitor follows and works at the
Operating System’s preset Screen Refresh
Rate�
Right Top
Left Bottom
Right Bottom
Customize
OFF
ON
Alarm Clock Location Left Top ■ Users can adjust Alarm Clock in any Mode�
■ After setting the time, press the Middle
Button to activate the timer�
■ Default Alarm Clock Location is Left Top�
Users can select their own location�
Right Top
Left Bottom
Right Bottom
Customize
OFF
15:00 00:01~99:59
30:00
45:00
60:00
Screen
Assistance
None ■ Users can adjust Screen Assistance in any
Mode�
■ Screen Assistance default is None�
Icon
Position
Reset
To Next Page
Loading...
Need help?
General
