In Command Mode:
Linux has built-in LPR client ,You can utilize it for printing.
You can manual set it or via the tool "printtool" in X-windows.
PS: The spool name is "lp"------all lowercase letter.
Below is my setting.
/etc/printcap
------------------------------------------------------------------------------
lp:\
:sd=/var/spool/lpd/lp:\
:mx#0:\
:sh:\
:rm=192.168.1.254:\
:rp=lp:\ -------------->key point
:if=/var/spool/lpd/lp/filter:
------------------------------------------------------------------------------
Then add the corresponding directory
#mkdir /var/spool/lpd/lp
Too see the detail ,please refer to the online manual in linux.
#man printcap
To Next Page
Loading...
