Chapter 3
BIOS Setup BIOS Setup
Resume By Onboard LAN [Disabled]
Disables or enables the system wake up by Onboard LAN.
[Enabled] Enables the system to be awakened from the power saving modes
when activity or input signal of LAN device is detected.
[Disabled] Disables this function.
Resume By USB Device [Disabled]
Disables or enables the system wake up by USB devices.
[Enabled] Enables the system to be awakened from sleep state when activity
of USB device is detected.
[Disabled] Disables this function.
Disables or enables the system wake up by PS/2 mouse.
activity of PS/2 mouse is detected.
[Disabled] Disables this function.
Disables or enables the system wake up by PS/2 keyboard.
activity of any key on PS/2 keyboard is detected.
activity of hot key on PS/2 keyboard is detected.
[Disabled] Disables this function.
Boot
Sets the sequence of system boot devices.
Full Screen Logo Display [Enabled]
Enables or disables to show the full screen logo while system POST.
[Enabled] The OS boots straight to the GUI without showing the POST screen.
[Disabled] Shows the POST messages at booting.
GO2BIOS [Disabled]
Enables or disables the system to power on and go to the BIOS setup directly by long
pressing the power button about 4 seconds when the system is off.
[Enabled] The system boots straight to the BIOS setup by long pressing the power
button about 2~4 seconds when the system is off.
[Disabled] Disables this function.
Boot Mode Select [LEGACY+UEFI]
Sets the system boot mode from legacy or UEFI architecture depending on OS
installation requirement. This item will become unselectable and will be configured
automatically by BIOS when “Windows 8/ 8.1 Feature” is enabled.
[UEFI] Enables UEFI BIOS boot mode support only.
[LEGACY+UEFI] Enables both Legacy BIOS boot mode and UEFI BIOS boot
mode.
FIXED BOOT ORDER Priorities
Sets device priority for system boot.
Boot Option #1~N
To Next Page
Loading...
