MSI Z170A GAMING M7 - Page 57

57
BIOS Setup
▶USB Con󰄈guration
Sets the onboard USB controller and device function. Press <Enter> to enter the sub-
menu.
▶USB Controller [Enabled]
Enables or disables all USB controller.
▶XHCI Hand-off [Enabled]
Enables or disables XHCI hand-o󰘯 support for the operating system without XHCI
hand-o󰘯 feature. This item will appear when USB Controller is enabled.
▶Legacy USB Support [Enabled]
Sets Legacy USB function support.
[Auto] The system will automatically detect if any USB device is connected
and enable the legacy USB support.
[Enabled] Enable the USB support under legacy mode.
[Disabled] The USB devices will be unavailable under legacy mode.
▶Power Management Setup
Sets system Power Management of EuP2013 and AC Power Loss behaviors. Press
<Enter> to enter the sub-menu.
▶EuP 2013 [Disabled]
Enables or disables the system power consumption according to EuP2013
regulation.
[Enabled] Optimize the system power consumption according to EuP 2013
regulation. It will not support S4 & S5 wake up by USB, PCI and
PCIe devices.
[Disabled] Disables this function.
▶Restore after AC Power Loss [Power Off]
Sets the system behaviors while encountering the AC power loss.
[Power O󰘯] Leaves the system in power o󰘯 state after restoring AC power.
[Power On] Boot up the system after restoring AC power.
[Last State] Restores the system to the previous state (power on/ power o󰘯)
before AC power loss.
▶On board LED Control [On]
Enables or disables the actions of onboard LEDs.
[On] Enables the actions of onboard LEDs.
[O󰘯] Disables the actions of power, reset, PCH, audio LEDs.
▶Windows OS Con󰄈guration
Sets Windows 8/ 8.1 detailed con󰘰guration and behaviors. Press <Enter> to enter
the sub-menu.