45
Overview of Components
Important
y
Users will try extreme low temperature overclocking at their own risks. The
overclocking results will vary according to the CPU version.
y
Please don’t switch to Enabled when power-off or the system will be un-bootable.
JSLOW_1: Slow Mode Booting Jumper
This jumper is used for LN2 cooling solution, that provides the extreme overclocking
conditions, to boot at a stable processor frequency and to prevent the system from
crashing. You can connect a button to this jumper, and press the button to enable the
Slow Mode.
JLN1: Low Temperature Booting Jumper
This jumper is used for liquid nitrogen cooling system to boot at an extreme low
temperature. Try to set it Enabled to increase the boot success rate.
Enabled
(Please enable this function
during BIOS POST.)
Enabled
(Please enable this function
during BIOS POST.)
Normal
(Default)
Normal
(Default)
JSLOW1
JLN1
JDISCH1: Discharge Jumper
You can discharge the motherboard by shorting the jumper instead of removing the
battery.
Discharge the motherboard
while the system is off
Normal
(Default)
To Next Page
Loading...
