To Next Page

To Previous Page

Overview of Components

2 14

1 LPC Clock 2

3V Standby power

3 LPC Reset 4 3.3V Power

LPC address & data pin0

6 Serial IRQ

LPC address & data pin1

8 5V Power

LPC address & data pin2

10 No Pin

LPC address & data pin3

12 Ground

13 LPC Frame 14 Ground

JTPM1: TPM Module Connector

This connector is for TPM (Trusted Platform Module). Please refer to the TPM security

platform manual for more details and usages.

JBAT1: Clear CMOS (Reset BIOS) Jumper

There is CMOS memory onboard that is external powered from a battery located on

the motherboard to save system configuration data. If you want to clear the system

configuration, set the jumper to clear the CMOS memory.

Keep Data

(default)

Clear CMOS/

Reset BIOS

Resetting BIOS to default values

1. Power off the computer and unplug the power cord

2. Use a jumper cap to short JBAT1 for about 5-10 seconds.

3. Remove the jumper cap from JBAT1.

4. Plug the power cord and power on the computer.

Questions and Answers:

Need help?

Do you have a question about the MSI Z270 SLI PLUS and is the answer not in the manual?

MSI Z270 SLI PLUS Specifications

General