What to do if bubble air blower does not work in mspa D-TE06 Tekapo?
If the bubble air blower in your MSpa Hot Tub isn't working, it could be due to bubble motor failure, in which case you should contact the MSpa Service Center. Alternatively, the system might have auto-off after 10 minutes; wait for 10 minutes and then try turning on the Bubble button again.
Why is my mspa D-TE06 Tekapo in an abnormal shape?
If your MSpa Hot Tub is in an abnormal shape, it could be due to extra air pressure caused by strong sunshine. Check the air pressure and release air if necessary. During hot weather, it's recommended to check if it's necessary to release some air to avoid any possible damage to the spa pool.
Key safety warnings and dangers to prevent injury, death, and property damage.
Instructions for testing PRCD and connecting equipotential bonding for electrical safety.
Step-by-step guide on how to inflate the MSpa using the controller and manometer.
Instructions for filling the spa with water to the correct level and temperature.
Explanation of the control panel buttons (Heater, Filter, Bubble) and their functions.
Solutions for control panel errors, power failures, and spa leaks.
Troubleshooting steps for heating system failures and bubble blower malfunctions.
To Next Page
General