2019-2020
Delight Service Manual
Visit our website at: www.the-mspa.com
- 18 -
3. Loosen five screws(ST4*15) from the rear cover
of the cabinet; Loosen two screws (ST4*15) from the
4. Take out the internal cabinet and power board
5. Loosen screws and dissemble the top cover from
the bubble generator
6. Remove the connection of leading wire and take out
the bubble generator
7. Put into the new bubble generator; assemble the
heat shirnkable sleeving; connect the leading wire
from the bubble generator and power cable.
8. Connect the transparent protective suit on the lead to
the joint，assemble the heat shirnkable sleeving; Tie
binding after fusing shrinkage
9、Assemble the control box in reverse order.
4.4 How to replace heating element(B9301193)
1、Take out the control box
、
Loosen four screws (ST4*60) from the bottom of the
cabinet
To Next Page
Loading...
