• Also, the engine of the device is not filled with oil during transport, but has only
traces of oil with which the internal components of the drive unit are lubricated.
Before starting the engine for the first time, the engine crankcase should be
topped up with oil through the dipstick hole with the machine on a level
surface:
The correct oil level should be within the allowable range on the dipstick, i.e.
grated field - after refilling the oil, wipe the dipstick dry, then insert it fully into
the hole and pull it out after a few seconds to check where the oil is reaching
the dipstick.
To Next Page
Loading...
Need help?
General