Need help?Do you have a question about the MT Helmets GENESIS SV and is the answer not in the manual?
Developed by MT HELMETS based on the revolutionary new ABS technology. Two shell sizes to optimize weight, fit and comfort.
The helmet features two air intakes located at the front, which enable the influx of cool air, while the warm air is effectively let out through its rear.
The pivoting mechanism of the MT-935 shield guarantees a uniform seal all around and allows the screen to be replaced quickly and easily.
The interior padding is not only made of hypoallergenic fabric that is removable and washable, but it also keeps you cool and dry in spring/summer and warm in cooler temperatures.
The deflector prevents circulating air from entering the helmet. It also helps to further reduce road noise inside the helmet.
Once the chinstrap is opened, you need to take both sections of the strap and keep them slightly separated in order to facilitate the passage of your head.
Release the retention chinstrap, hold the two sections slightly apart as explained in the previous paragraph and remove the helmet.
The micrometric closure allows for easy and precise adjustment of the chinstrap length.
There are 3 snaps that hold the side pads in place. Gently lift the side pad away from the shell in order to release the snaps.
Pass the strap through the opening of the pad at cheek level. Align and slide the plastic cheek pad plate into place between the shell and the EPS.
Press the trigger located at the lower front part of the chin bar. While holding down this trigger, lift the chin bar to its highest point.
Move the side tab down to unlock the chin bar. Lower the chin bar until you hear the lower trigger click.
The shield closes with an optimal airtight seal. Push the shield upward to ensure that it is in the open position. Lower the shield until you hear a click.
Push up the side tab located on the left side of the helmet to deploy the sun visor. Push down the side tab located on the left side of the helmet to retract the sun visor.
Lift up the shield to its maximum raised position. Slide the actioning mechanism down to release the shield.
Align the shield with the mounting position. Press the shield until you hear a click.
Activate the sun visor and raise the clear screen. Press from inside outwards firmly to remove the sun visor.
Ensure that the sun visor mechanism is in the correct position. Insert the sun visor into the same slots from which it was removed until you hear a 'click'.
Slide down the air intake lock mechanism to activate the incoming airflow. Slide it upwards until you hear a click, to deactivate the incoming airflow.
Slide backwards the air intake lock mechanism to activate the incoming airflow. Slide it forwards until you hear a click, to deactivate the incoming airflow.
No component of your helmet can be damaged by water. Wash it with a mild detergent in lukewarm water and let it air dry.
Do not ride without first carefully fastening your helmet. Do not clean your helmet with petroleum products, solvents, benzene, thinners or abrasive cleaning products.
If you have a warranty claim, please go to mthelmets.com/warranty
General| Brand | MT Helmets |
|---|---|
| Model | GENESIS SV |
| Category | Motorcycle Accessories |
| Language | English |
To Next Page
