TAEevo M05-M10
7
MAINTENANCE AND OPERATING MANUAL
The data inside this manual are not binding and they can be modified by the manufacturer without notice. All rights reserved.
Other data for standard units:
NOTE
Standard pumps are of peripheral type, so the pump heads indicated in the table are respectively at no flow and at max. flow. It is possible for
the pump installed to be different from the standard one. In this case reference should be made to the data in the offer.
NOTE
The pump must never run dry.
3.1.1 Sound Level Measurements
* at distance of 1 metre (3,2 FT)
** global
Test conditions
Noise levels refer to operation of the unit at full load in nominal conditions.
Sound pressure level in hemispherical irradiation conditions at a distance of 1 m (3,2 FT) from the condenser side of the unit and height of 1.6 m
(5,2 FT) from the ground. Values tolerance ± 2 dB.
Sound power level: in compliance with ISO 3744
3.1.2 Limit operating conditions
(1) For temperatures below +5°C use antifreeze solutions (see 5.3 “Antifreeze protection” ).
TAEevo MODEL M05 M10
Tank capacity [litres] 25 25
P3 NoFe
water flow rate [l/min] 8/40 8/40
pump head [bar] 4/0 4/0
nominal power [kW] 0,33 0,33
type peripheric
Table 3 P
ERFORMANCES
Lp dB(A) * Lw dB(A) **
TAEevo M05 63,3 76,3
TAEevo M10 63,3 76,3
Minimum Maximum
Ambient air temperature °C 5 40
Evaporator water inlet temperature °C 5 35
Evaporator water outlet temperature °C 0(1) 30
0
5
10
15
20
25
30
35
40
45
50
0 10203040
PRESSURE mca
FLOW RATE l/min
PUMP HEADS
To Next Page
Loading...
