EasyManua.ls Logo

MTD 760 - Tire Pressure, Battery Care, Charging, and Jump Starting

MTD 760
36 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3atteries giveoff an
_:xplosivegas while
;barging Charge bat-
tery in a well ventilated
area and keep away
from an open flame
or pilot light as on a
water heater, space
tleater, furnace, clothes
dryeror other gas
ippliances
Always use afuse with
the same amperage
capacity for replace-
ment
Jump Starting
,_ WARNING: Never exceed the
maximum inflation pressure
shown on the sidewall of tire.
Therecommendedoperatingtire pressureis:
,, Approximately10psi for the reartires
,, Approximately14psi for the fronttires
iMPORTANT:Refertothetiresidewallforexacttire
manufacturer'srecommendedormaximumpsi.Do not
overinflate.Uneventire pressurecouldcausethe cutting
decktomowunevenly.
Battery
Thebatteryis sealedandis maintenance-free.Acid
levelscannotbe checked.
Alwayskeepthe batterycablesandterminalsclean
andfreeof corrosivebuild-up.
Aftercleaningthe batteryandterminals,apply a light
coatofpetroleumjellyor greasetoboth terminals.
Alwayskeepthe rubberbootpositionedoverthe
positiveterminalto preventshorting.
IMPORTANT:If removingthe batteryforany reason,
disconnecttheNEGATIVE(Black)wirefromit'sterminal
first,followedbythe POSITIVE(Red)wire.When
re-installingthebattery,alwaysconnectthePOSITIVE
(Red)wire itsterminalfirst,followedbytheNEGATIVE
(Black)wire.Becertainthat thewiresareconnectedto
thecorrectterminals;reversingthemcould changethe
polarityandresultindamageto your engine'salternat-
ingsystem.
Charging
If thetractorhasnotbeenputintousefor anextended
periodoftime,chargethebatterywith anautomotive-
type 12-voltchargerfora minimumof one hour at six
amps.
WARNING: Batteries give off an
explosive gas while charging.
Charge battery in a well venti-
lated area and keep away from
an open flame or pilot light as
on a water heater, space heater,
furnace, clothes dryer or other
gas appliances.
WARNING: When removing or
installing the battery, follow
these instructions to prevent the
screwdriver from shorting against
the frame.
iMPORTANT:Neverjumpyourtractor'sdeadbatterywith
thebatteryof a runningvehicle.
1. Connectendof onejumpercabletothepositive
terminalofthegoodbattery,thentheotherendto the
positiveterminalof the deadbattery.
2. Connectthe otherjumpercableto the negative
terminalofthegoodbattery,thentotheframe of the
unit withthe dead battery.
,,_ WARNING: Failure to use this
procedurecould cause sparking,
and the gas in either battery could
explode.
Cleaning
Cleanthe batterybyremovingit fromthe tractorand
washingwitha bakingsodaandwatersolution.If neces-
sary,scrapethe batteryterminalswitha wire brushto
removedeposits.Coatterminalsandexposedwiringwith
greaseor petroleumjellytopreventcorrosion.
Battery Failures
Somecommoncausesfor batteryfailureare:
,,incorrectinitialactivation ,,undercharging
,,overcharging ,,corrodedconnections
,,freezing
Thesefailures are NOTcoveredby yourtractor's
warranty.
Fuse
One20AMPfuseis installedin yourtractor'swiringhar-
nesstoprotectthe tractor'selectricalsystemfromdamage
causedbyexcessiveamperage.
If the electricalsystemdoes notfunction,oryourtractor's
enginewillnotcrank,first checktobecertainthatthefuse
hasnotblown.It canbefoundunderthe hoodmounted
behindthedashpanelon therightside.
_ ARNING: Always use a fuse with
the same amperage capacity for
replacement.
24

Related product manuals