MTD Bolens 11A-414A065 User Manual

Read and understand all instruction, warning, and danger labels.
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY AND
FOLLOW THE SAFE OPERATION PRACTICES BEFORE OPERATING .
Lea el manual de operación anexo sobre ensamblaje e inicio.
Need Help? Call 1-888-TO-HELP-U (1-888-864-3578)
778-11649
11A-414
1
2
Use cable tie to
secure cable to
lower handle.
4
3
Starter
Rope
Refer to Operator’s Manual for instructions on attaching the grass catcher.
© 2008
Star Knobs
Blade Control Handle
A
B
(A) Lift handle
to extended
position.
(B) Tighten star
knobs.
(A) Hold blade
control handle
against upper
handle.
(B)(C) Slowly
pull starter rope
from engine and
slip starter rope
into rope guide.
(D) Tighten
rope guide wing
knob.
Place ends of lower
handle onto handle
brackets. Insert
carriage bolts and
tighten with wing nuts.
A
C
D
B

MTD Bolens 11A-414A065 Specifications

General

Cutting Height Adjustment	Dual-lever
Mulch Capable	Yes
Side Discharge	Yes
Rear Bag	Yes
Engine Type	4-Cycle
Engine Displacement	140cc
Cutting Height	1.25 to 3.75 inches

Summary

Initial Setup and Assembly

Adjusting the Handle

Lift the handle to its extended position and tighten the star knobs.

Connecting the Lower Handle

Attach the lower handle to the brackets with carriage bolts and wing nuts.

Preparing the Starter Rope

Hold the blade control handle and guide the starter rope into the rope guide.

Securing the Cable

Use a cable tie to secure the cable to the lower handle.

Engine Preparation and Starting

Fueling the Tank

Fill the gas tank up to within 1/2-inch of the top; do not overfill.

Adding Engine Oil

Add the entire contents of the supplied oil bottle to the engine; do not overfill.

Priming the Engine

Push the primer five times to prepare the engine for starting.

Starting the Engine

Pull the starter rope with a quick, full arm stroke. Repeat if necessary.