General Specifications
- Power Supply: 21.5V alkaline batteries (LR6)
- Battery Life: about 400mA/3V under the condition
of 10mA with 1kΩ load
- Max. permitted Voltage: 30V(between any two
terminals or between any terminal and earth
ground)
- Operating temperature: 0℃ to 50℃
- Operating relative humidity: ≤ 80% RH
- Storage temperature: ≤ -10℃ to 50℃
- Relative humidity for storage: ≤ 90% RH
- Temperature co-efficiency: 0.1×（designated
accuracy）%/℃（5℃～18℃、28℃～40℃）
- Size: 180（L）×90（W）×47（D）mm (with
holster)
- Weight: 500g(with holster)
- Accessories: Operation instruction, a set of CF-36
industrial test lead(with alligator clips attached to
probes)
- Safety: Certified as compliant to IEC1010
provisions(Safety standard issued by International
Electrotechnical Commission)
Section Nine: Calibration
Note
Calibration: In order to keep the designed
accuracy of this Instrument, it is recommendable to
calibrate your calibrator once a year. The following
example shows the use of recommended standard
equipment to perform the calibration.
Caution
Usage：Never apply more than the max.
permitted voltage to the input of the calibrator,
otherwise the overvoltage will lead to possible
damage to the input section.
Usage: during the operation, avoid short
circuit and never apply more than the max.
permitted voltage to the output of the Instrument or
to a co-working standard device, otherwise any
mal-operation will cause possible damage to their
internal circuits.
To Next Page
Loading...