What to do if there is coolant discharge at intercooler of MTU 16V4000G34F?
If you notice coolant discharge at the intercooler of your MTU Engine, and it seems like a major coolant discharge due to leaking, contact service.
General| Engine Model | 16V4000G34F |
|---|---|
| Speed | 1800 rpm |
| Rated Speed | 1800 rpm |
| Number of Cylinders | 16 |
| Bore | 170 mm |
| Stroke | 210 mm |
| Compression Ratio | 16.5:1 |
| Cooling System | Water-cooled |
| Emissions Compliance | EPA Tier 2 |
| Engine Type | Diesel |
General safety provisions for all products, including risks and nameplates.
Requirements for power generation products, operational environment, residual hazards, and noise.
Defines the intended use of Gendrive engines and modifications/conversions.
Requirements for personnel, training, and personal protective equipment.
Regulations for initial start-up, operation, malfunctions, and emergency stops.
Safety regulations for work prior to, during, and after assembly, maintenance, and repair.
Fire prevention, noise, environmental protection, disposal, and fluids/lubricants safety.
Special tools, material, spare parts for transport, and general transport instructions.
Safety warnings and specifications for lifting engines/generators, including center of gravity.
Key for reference values, product data table, and reference conditions for 12V engines.
Key for reference values, product data table, and reference conditions for 16V engines.
Provides an overview of the engine's driving end (KS) and free end (KGS).
Describes the fuel system, technical data, benefits, and operation of the Common Rail system.
Details the charge-air and exhaust system components, technical data, benefits, and operation.
Details engine management, monitoring systems, engine governor ECU 9, technical data, and functions.
Preconditions and steps for putting the engine into operation after extended periods of inactivity.
Preconditions, preparation, starting the engine, and connecting the generator for warm-up.
Notice regarding restarting after safety shutdown and procedure to follow.
Explains the override function for safety and shutdown alarms in emergency situations.
Details operational monitoring of control panels, engine oil, fuel prefilter, exhaust, intercooler, and air filter.
Procedure for emergency engine start using override mode, including preparation and connection to mains.
Preconditions and steps for stopping the engine in manual mode, including generator preparation.
Procedure for emergency engine stop using the pushbutton and actions after an emergency stop.
Reference table for maintenance tasks and intervals, linking to the Maintenance Schedule.
Covers SS T-Coolant Intercooler, P-Lube Oil, and Coolant Level fault messages.
Troubleshooting for refdrive impossibilities and engine operation point faults.
Outlines the steps for performing an engine test run and operational checks.
Preconditions, special tools, preparatory steps, diagrams, and checking/adjusting valve clearance.
Special tools, material, spare parts, and overview of injector replacement.
Preconditions, special tools, warnings, nameplate details, and steps for removal/installation.
Preconditions, special tools, warnings, and steps for replacing the fuel filter.
Preconditions, special tools, warnings, and steps for draining and filling engine oil.
Preconditions, special tools, warnings, and steps for replacing the engine oil filter.
Note on emissions certification and procedure for resetting drift correction parameters with DiaSys®.
Details tightening torques for SAE sealing cone with union nut JIC 37° and ORFS.
To Next Page
